Plan the pull
Confirm route, length, depth, utilities, pipe material, connections, and equipment access.
No. Bursting replaces pipe along a reusable route but still needs access for the equipment, new pipe, and connections. Nearby utilities, bends, and available working space can affect suitability. The estimate should locate the openings and explain what conditions could require additional excavation.
Compare access and excavation requirementsAsk where the pull equipment and pits will sit. On a tight lot, nearby utilities, foundations and walls can constrain the route. Coordinate Colorado 811 markings and any private locates needed before the crew starts.
A route crossing hard ground may make fewer openings appealing. Still ask whether the path is straight and suitable enough and how the contractor checked grade. A collapsed or badly displaced section can change the approach.
The bid should show the pipe length, both tie-ins, the condition that could force an extra opening and what happens to each surface after the work.
Confirm route, length, depth, utilities, pipe material, connections, and equipment access.
Excavate entry and receiving areas sized for the bursting head and new pipe. Before pipe bursting, verify that the entry and receiving pits fit the route, utilities are marked, and there is room for the pull.
Pull the head through the old line while the new pipe follows the same general path.
Make building and downstream connections, test the line, backfill pits, and restore surfaces.
Long runs where avoiding an open trench may protect more of the surface. These conditions can extend beyond a single repair point, so the full accessible route should be reviewed. Compare replacement methods against pipe condition, connections, access, and restoration.
A host line that should be replaced rather than used to support a liner. These conditions can extend beyond a single repair point, so the full accessible route should be reviewed. Compare replacement methods against pipe condition, connections, access, and restoration.
Projects with workable pull length, access pits, and manageable connections. This method depends on the pipe, route, connections, and access meeting its requirements. A site evaluation should explain any access pits, preparation, or restoration that may still be needed.
No. It reduces continuous trenching but normally requires entry and receiving pits plus excavation at connections.
Some projects can install a larger line, but soil, utilities, route, connections, local requirements, and equipment determine what is practical.
The bursting head fractures or displaces it into the surrounding soil while the new pipe occupies the route.
No. Material, reinforcement, repairs, encasement, bends, and nearby utilities can limit or prevent the method.
No-dig sewer repair and replacement options for suitable underground lines.
Explore →SERVICEFull or partial replacement for collapsed, severely deteriorated, or repeatedly failing pipe.
Explore →SERVICECreate a new cured-in-place interior surface within a suitable existing pipe.
Explore →A bursting proposal needs more than a damaged-pipe diagnosis. The existing route, nearby utilities, connections, soil conditions, and room for entry and receiving pits all need review.
Pit locations, lateral connections, pipe length, utility conflicts, and restoration drive the scope. Ask what conditions could require open excavation even when most of the replacement uses bursting.
Sewer repair cost factors · Check service areas
Start with your name and phone number. You can discuss the property and symptoms during follow-up. Request a callback.