Colorado Springs, Colorado · Residential Sewer Lines
Have a sewer line problem?Request a callback
Sewer & Drain Services

Sewer Pipe Lining in Colorado Springs, CO

A liner can make sense when the sewer runs under concrete and the old pipe still has a usable path. The crew cleans the line first, then installs and cures the liner inside it. Standing water in the same stretch on repeat camera passes deserves a different conversation, because lining follows the existing grade. Ask where the liner will start and stop and what the footage shows at both ends.

Ask to see the footage after cleaning. It’s easier to judge the host pipe when roots and loose debris are out of the camera’s way.

If another branch feeds into the section being lined, have the contractor point it out and explain how the connection will be handled.

Get the start and end points of the liner in writing. That way you know which sections of the old sewer will still be in service afterward.

Colorado Springs, Colorado · Sewer & drain information
The short answer

What can sewer pipe lining fix—and what stays in place?

A suitable liner renews the interior of the existing pipe, so the host route and its general grade remain important. The line must be assessed and prepared, and branch connections accounted for. Ask how the proposal addresses any standing water, severe offset, or section that cannot be inspected.

Compare lining with other trenchless methods
Start with the condition

Check whether the host pipe is a candidate

Ask for footage after cleaning. Have the bidder point out bends, offsets, standing water and connections. A liner follows the path already there, so ask how the proposal deals with any section that has lost its grade.

Review access and connections

If a walkway or driveway is driving the decision, mark the proposed access openings and ask how any connections will be handled. Compare the portion lined, preparation, verification and surface restoration across bids.

Ask what the result will look like

Have the provider define the length and the acceptance checks in writing. Keep the final video and the location of any access added. If sections were left out, ask where and why.

When to take a closer look

Signs That May Point to Sewer Pipe Lining (CIPP)

  • Cracks or joints extend along a usable pipe run
  • Roots repeatedly enter through multiple joints
  • The route lies beneath a driveway, patio, or established landscaping
  • The host pipe remains open but has a rough deteriorated interior
  • A continuous repair is preferred over several separate spot excavations
What the work involves

A Practical Sewer Pipe Lining (CIPP) Process

01

Clean and measure

Remove roots and buildup, inspect the full run, and confirm diameter and liner length.

02

Prepare the liner

Select the liner and resin system and position it for the intended host pipe. Choose a liner and resin system for the host pipe’s diameter, route, and the specified installation and curing method.

03

Install and cure

Invert or pull the liner into place, then cure it using the specified process. For CIPP, confirm liner length and diameter, branch reconnections, cure method, final inspection, and any restoration excluded from the estimate.

04

Reopen and inspect

Restore required branch connections and record the finished interior condition. The review should connect the symptom to a location and the visible pipe condition, including what remains sound beyond the trouble spot. Keep the footage or findings with the estimate so the recommended work can be compared with what was actually observed.

Where it may fit

Situations This Service Commonly Addresses

Cracked or jointed pipe

A continuous run with defects but enough remaining structure and alignment for lining.

Root-prone laterals

Multiple root-entry joints that can be covered by a continuous liner. Clearing can restore flow, but it does not close the point where roots entered. A camera review after cleaning can show whether a spot repair or a broader pipe solution fits.

Hard-to-restore surfaces

Routes where avoiding a long open trench may reduce property disruption. This method depends on the pipe, route, connections, and access meeting its requirements. A site evaluation should explain any access pits, preparation, or restoration that may still be needed.

Before work begins

Questions and Details Worth Confirming

  • Confirm the exact start, end, and finished diameter of the liner.
  • Ask how branch connections will be reopened and documented.
  • Review the liner warranty, exclusions, and host-pipe assumptions.
  • Lining does not normally correct a significant belly or poor grade.
Clear answers

Sewer Pipe Lining (CIPP) FAQs

Does pipe lining make the sewer line too small?

A liner reduces the inside diameter somewhat, but its smooth surface can still provide suitable flow when the line is properly designed and installed. The provider should explain the finished diameter.

Can a collapsed sewer line be lined?

Not through a fully collapsed section without restoring an open path. Local excavation may be needed, or a different replacement method may be more appropriate.

How are connections handled after lining?

Branch connections may need to be reopened with specialized equipment. The scope should identify known connections and how they will be verified.

Will lining stop tree roots?

A continuous liner can cover many root-entry cracks and joints within the lined section. Roots can still exploit unlined defects or connection points, so the full route matters.

Planning pipe lining

What the assessment should establish

Lining starts with a camera review and a check of whether the existing pipe can support the proposed system. Cleaning requirements, connections, pipe shape, and standing water need to be understood first.

What affects the estimate?

Preparation, liner length and diameter, reinstating connections, and post-installation inspection affect the price. Ask how the proposal handles an unsuitable section discovered during preparation.

Sewer repair cost factors · Check service areas

Start with your name and phone number. You can discuss the property and symptoms during follow-up. Request a callback.

Ready to describe the issue?

Start by describing the symptoms.

Request an Estimate →
Clean and inspect the host pipeConfirm lining suitabilityCure and inspect the finished liner
Call 719-315-7400Request an Estimate →

Thank you!

Your request has been sent. We’ll follow up using the phone number you provided.

Need to speak with someone? Call 719-315-7400.